Description ***** Sorry we are unable to send these items outside of the UK***** Selected MaxxECU advantages Built-in MAP-sensor (up to 43 psi / 3bar of boost pressure) MDash/RealDash Android app connectivity Superfast USB communication High or low impedance injector support No changes in original electronics Direct access to 6 EGT-sensors Selected vehicle features Uses stock harness, easy installation The air mass meter is removed Controls idle valve, AC, tachometer and other instruments Controls E-Throttle, EVAP and other valves Full CAN bus control of the stock dash Uses stock wideband oxygen sensor(s) Selected MaxxECU functions Boost control Launch control Shift-cut Lambda control Boost level switching Compatibility Compatible with MaxxECU RACE Some features not available depending on used ECU MaxxECU RACE Full Feature List Target engines of MaxxECU RACE All 3-12 cylinder engines (4-stroke) Up to 8 cylinders fully sequentially Up to 12 cylinders in wasted spark MaxxECU RACE inputs Intake air temperature sensor (IAT) Coolant temperature sensor (CLT) Throttle position sensor (TPS) Lambda (WBO) sensor. Uses a sensor directly connected to the ECU without any additional electronics. Supports Bosch LSU 4.2 and 4.9 2 trigger inputs. VR or digital. Automatic trigger level detection. The signals are processed by a completely separated processor for maximum performance and immunity against interference 2 extra temperature sensors. Can be used as switches or control of additional functions 2 knock sensor inputs 6 extra 0-5V inputs. Can be used for additional sensors such as measurement oil/fuel pressure 4 extra digital inputs used for example speed sensors (VR / Hall) or switches 8 EGT TYPE-K/N inputs (1200C/2200F) in separate harness MaxxECU RACE outputs 8 peak/hold injector outputs. 1-2 high or low impedance injectors per output. 8A per output 8 ignition outputs. 5V signal to drive ignition modules, CDI units or coils 9 extra LOW DRIVING outputs for additional features. Can be adjusted to control virtually anything like fuel pumps, idle valves. GPO 1-8,10 (2A), GPO 9 (5A) 2 extra 12V DRIVING outputs (GPO 15,16) (2A) 4 extra motor outputs (ex E-Throttle). GPO 11-14 (2A) MaxxECU RACE technical CAN bus for expansion modules, OEM vehicle CAN, ODBII USB communication for tuning with M Tune Bluetooth for connecting to mobile devices with MDash 8MB memory for internal logging, up to 1000Hz. Supply voltage 8-22V ARM Cortex-M3 120MHz main processor. Three extra processors to handle the trigger, injectors and knock detection Resolution on ignition: 0.1 degrees Resolution on injectors: 0.001 ms Updates the fuel and ignition calculations 2000 times per second The fastest PC communication on the market 50Hz sampling rate on all EGT inputs 1000Hz sampling rate on all analog inputs Weight: 880g 155x195x40mm (including mounting points, excluding connector) All MaxxECU products are using high quality Automotive Molex connectors. We can help with supply of sensors or any other MaxxECU products and related support. Any enquiries please contact us via one of the methods below. Majority of MaxxECU products will come from the main distributor with a few days delay to the order.
