Description This exhaust system is part of our MIJ Performance Exhaust range — designed, developed, and hand-built in-house by our skilled technicians. We don’t resell or rebrand generic systems — every exhaust is crafted to order using premium T304 stainless steel, ensuring a perfect fit, exceptional durability, and performance you can trust. When you buy from us, you’re buying direct from the manufacturer, not a middleman. Direct Fit Exhaust System For Renault Avantime 2L Fits directly after the cat What you get: Middle and Rear sections of the exhaust No gaskets are supplied, only bolts and nuts so be sure to keep your old ones OR to source a new set prior to fitting this system. What “Direct-Fit” Means When we say Direct-Fit, we mean this system is designed to bolt or clamp straight onto your vehicle using the original mounting points — no cutting, welding, or modifications required. This system replaces your middle and rear sections as one complete unit. We do not sell this system as separate parts. It is sold as a full, complete exhaust system only, engineered and tested to work together as a matched setup. REPLACE IT ONCE — NEVER AGAIN This is our own brand exhaust system. We are an established exhaust manufacturer — buy with confidence. Key specs: Hand built in the UK to the highest standard Made from T304 stainless steel Anti-magnetic material Much less susceptible to rust compared to mild-steel systems Full-flow mandrel bends for excellent gas flow Free-flow design for increased power & efficiency Why free-flow matters All of our exhausts are free-flow systems — meaning minimal internal restriction. Factory/OEM silencers contain chambers & baffles to reduce noise — this slows the gas speed and increases back-pressure. Our systems remove these internal restrictions → improving exhaust velocity & engine breathing → resulting in measurable performance gains. Each system is built & set up to suit this exact model, based on our own research, development, and test data. Performance gains are noticeable on all our systems. We don’t just replace an exhaust — we build an upgrade designed to be installed once and last. Tips When Fitting Professional fitting is recommended for best alignment and long-term results. • Do not remove your existing system until your new exhaust has arrived and has been checked against your vehicle. • Always lay the new system next to the existing system to visually compare lengths, hanger positions and pipe routing before cutting anything. • Ensure the vehicle is level when fitting — not half-raised on one side. Fitting at an angle can cause poor alignment, tailpipe twist, leaks and stress points. • Loosely assemble all joints first — do not fully tighten clamps until the entire system is lined up, supported and sitting naturally in position. • Once aligned, tighten clamps from front to back to avoid twist and movement. • After initial fitting, re-check clamp tightness after a short drive — stainless steel expands and seats itself once heat cycled. • We ship using third-party couriers, so delivery times can vary — please do not book workshop labour until you physically have the exhaust in your possession. Shipping / Lead time As we manufacture in-house, please allow up to 3 working days for production and dispatch (up to 5 days during busy periods). We ship worldwide. International buyers: Import duties/taxes are not included and are the buyer’s responsibility. Check with your customs office for estimated fees before ordering. Buy with confidence from a well established exhaust manufacturer and supplier.
